Round Belt Welding Tools

Poly cord Joining Tool – Round belt Welding Tools

belt welding machine is a device that used for jointing polyurethane round and v-belt. which included:

• 1 pcs of electric solder iron; temperature:150-400℃ adjustable, heat wand is hold a constant temperature by heating to a certain temperature (working temperature usually between 250-300 degrees), Power:200W, Voltage: AC 220V/50Hz or AC 110V/60Hz as options.
• 1 pcs of clamp; for small diameter of round belt, please put the round belt on the top of the tank there, so that the round belt 2 connector alignment; for larger diameter of round belt or red pu v-belt, please put them on the bottom inside of groove! The belt to be connected is fixed in the groove (usually V, O-groove) below the aluminum fixture (the clamp main refers to the gasket and nut).Specifically, remove the nuts on both sides of the nut and nuts (depending on the diameter of the belt, if the belt can be inserted directly into the groove, do not remove the nut and gasket), the belt into the groove, the gasket and Nuts re-fixed in the groove above the sides of the plywood in a parallel state, the spacing is about 2cm or so is appropriate (can be placed in the middle of the thermostat heater)
• 1 pcs of belt cutter; Use scissors to cut two ends of the belt flat.

Please contact us for further need regard Round Belt Welding Tools