Polycord Welder

Polycord welding kit – Polycord Welder

Polycord joining tool can connect most type of polyurethane round belts and v-belt for butt heat welding

• 1 pcs of 220V -constant temperature soldering iron
• 1 pcs of clamp
• 1 pcs of Scissors for cut belt

Use Manual for Poly cord Welder

1. Pre-heat the soldering iron, cut the belt by the scissors, make sure the transverse incision is flat and smooth.
2. Loosen the four big screws of the welding clamp, adjust the height of aluminum plates to put the belt into it.
3. Put the two ends of belt into the locating slot (If the belt size is small, adjust the four small screw of clamp to fit it.), preset protruding length on both ends of the belt, make the two end of belt match perfectly.
4. Place the soldering iron between two ends of belt, gently tighten the clamp, make both ends completely touch soldering iron.
5. Heat the soldering iron, when the PU are melted and effluent approximately 0.5~1mm, take out the soldering iron quickly, fasten the welding clamp by the side screw.
6. Natural cooling about 3 minutes, then take off the belt.
7. Grinding the joint smoothly check both ends of belt are vertical and fix if not please repeat the above steps again.

Please Contact us for further need regard polycord welder.