Polyurethane Belt Welder

Polyurethane Belt Welder – Round Belt Welder

Poly cord belt welder can joining most type of PU round belts and v-belt.

• 1 pcs of 220V-Adjustable soldering iron;
• 1 pcs of welding clamp;
• 1 pcs of Scissors.

Operating Instruction of Polyurethane Belt Welder

1. Pre-heat the soldering iron, cut the belt by the scissors, make sure the transverse incision is flat and smooth.
2. Loosen the four big screws of the welding clamp, adjust the height of aluminum plates to put the belt into it.
3. Put the two ends of belt into the locating slot (If the belt size is small, adjust the four small screw of clamp to fit it.), preset protruding length on both ends of the belt, make the two end of belt match perfectly.
4. Place the soldering iron between two ends of belt, gently tighten the clamp, make both ends completely touch soldering iron.
5. Heat the soldering iron, when the PU are melted and effluent approximately 0.5~1mm, take out the soldering iron quickly, fasten the welding clamp by the side screw.
6. Natural cooling about 3 minutes, then take off the belt.
7. Grinding the joint smoothly check both ends of belt are vertical and fix if not please repeat the above steps again.

Please Contact us for further need regards Polyurethane Belt Welder